How to Use Guide

Weelchair Customized

Placing the SitStand

PRIOR TO PLACING THE SITNSTAND, MAKE SURE THAT THE WHEELCHAIR BREAKS ARE LOCKED

  • A. Place the SitnStand folded on the wheelchair -
    Illustration A.
  • B. Insert the back part / Air Supply area between the back and the seat of the wheelchair -
    Illustration B.
  • C. Place the air supply unit's slings on the wheelchair's handles and tighten them up -
    Illustration C.
  • D. When not in use we recommend you attach the remote control to a velcro strip that will be attached to the wheelchair push handles -
    Illustrations D1 + D2.
1

Sitting Down

LOCK THE WHEELCHAIR BRAKES BEFORE SITTING DOWN!

  • A. Sit Comfortably in the center.
  • B. Start deflating by pressing the “Down” arrow button.
  • C. You Can Now Sit Down Comfortably.

**NOTE:

When using the battery for the first time it should be charged for at least 12 hours.

2

Standing Up

LOCK THE WHEELCHAIR BRAKES BEFORE SITTING DOWN!

  • A. Take your feets off the wheelchair paddes and place them on the floor, close to the chair.
  • B. Sit upright.
  • C. Spread your feet.
  • D. Inflate the cushion by pressing the “Up” button.
  • E. Now you can easily Stand Up.

**NOTE:

Incase of cognitive imperiment the SitnStand should only be oparated by a caregiver.

3

Get to Know the Remote Control

**NOTE:

Standby mode- flashes slowly (one flash/sec) | Working mode - flashes quickly (5 flashes/sec) | Malfunction reset - press the two control buttons simultaneously for 10 secs. If that doesn’t help, please contact us at – info@sitnstand.com

4

Standing Up

  • A. Remove battery by sliding it towards you.
  • B. Connect battery to the charger as illustrated.
  • C. When the “Red” light on the charger changes to “Green”, the battery is fully charged.
  • D. Slide the charged battery into its place.

**NOTE:

When using the battery for the first time, it should be charged for at least 12 hours.

5